1. It uses an electrochemical carbon monoxide sensor-the most accurate technology 2. The permanent sensor lasts up to five years 3. The detector is easy to install and use. 4. A perfect item for protecting your family from the dangers of carbon monoxide Green LED: Flashes every 30 seconds to indicate the unit is operating properly. The green LED will also flash before CO reading is taken and when any button is pressed. Red LED : When a dangerous level of carbon monoxide is detected the red LED will pulse and a loud alarm pattern will sound. Specification: Power Supply: 3 AA size 1.5V batteries (battery not included) Sensitivity & Time: 50ppm, alarms within 60-90 minutes 100ppm, alarms within 10-40 minutes 300ppm, alarms within 3 minutes Standby Current: < 50uA (without LCD); < 200uA (with LCD) Alarm Current: < 75mA Operation Ambient Condition: 5~40,Â°20~90% R.H. Cautions: 1. Mounted on a wall. 2. Do not install in garages, kitchens, furnace rooms or bathrooms! 3. Install at least 15 feet away from any fuel burning appliance. 4. We suggest an alarm be installed on each level of a multilevel home 5. Needs to be tested weekly!
LCD monoxide detector
No wires needed
Family protected from 'Silent Killer'
Loud 85 decibel alarm
Within 60~90 minutes at 50ppm CO concentration;
Within 10~40 minutes at 100ppm CO concentration;
Within 3 minutes at 300ppm CO concentration
The alarm sound pattern is four short alarm beeps. The red LED will flash while in the alarm mode.
One chirp every 30 seconds in an indication that the battery is low (need replacement) (green LED still flashes once every 30 seconds).
Test/Reset button to test the unit electronics and verifies proper unit operation and reset the unit during CO alarm.
Alarm memory feature: If the unit ever alarms, pressing the button, green LED will flashes once every second for one minute and the peak alarm level will be indicated on the LCD.
Green and red LED lights that indicate normal operation and alarm status.
The unit will sound chirp and red LED flashes once as power up.
Green LED: Flashes every 30 seconds to indicate the unit is operating properly. The green LED will also flash before CO reading is taken and when any button is pressed.
Red LED: When a dangerous level of carbon monoxide is detected the red LED will pulse and a loud alarm pattern will sound.
The carbon monoxide alarm pattern is 4 short beeps, followed by 5 seconds of silence, followed by 4 short beeps with a corresponding red LED flash. This cycle will continue for 4 minutes and then change to 1 cycle every minute until the device is reset or the CO is eliminated.